New computer suggestions

[Dedeye Profile]

I have the same case, and love it.

With all the fans on Med, once you start gaming, you won't even notice.

My only beef is it collects alot of dust and crud (ha) on the front fans, where is sucks in the air. Not too bad, but my case also is close to the floor, prob the main reason.

Nice system, looks good.

[Verman Profile]

I'd be willing to bet the cpu fan is making the most noise. If you went with a different cooler it would help. I like the Zalman cooler. It comes with a speed control that you can put on the back of the case. Also, if you run your cables through the slots in the back plate you will have much better air flow. With cpu fan turned down and all fans on low, not much of a cpu temp increase. Very quiet, runs fine, even gaming. Video cards make the most noise with this setup. If OCing you would want to turn fans up for sure.



*edit*
Shit, I just took a look at my fan speeds and they are on low. Except cpu fan. It's about Mid.
Just turned my cpu fan down. The only noise I hear is video cards. Then again I'm old

Also, you should probably move the stick of ram closest to the front over 1 slot. To the blue one.

[DOZER Profile]

[UW Ness Profile]

Yeah it's the stock one. Doing fine so far, might upgrade to a aftermarket one in the future. And I'll probably grab another 2gig stick of ram for shits sometime. Quick question though, I want to get another fan for the side, partially for looks but then I will be comfortable keeping all the fans on low. What size fan will fit on there?

[DOZER Profile]

it uses 120mmx25mm fans. An Antec tri-cool would go well with the rest of the fans in the case. check out sites like this when you go to re-do
all you cable managment and clean up on a rainy day, shows you alot of options for you stuff as well.
http://www.hardforum.com/showthread.php ... =antec+900 there are madd pages to scroll through, have fun man.

[Grouch Profile Website]

If i go to the next Lan everyone with an ANtec 900 case should line them up. Would look pretty cool next to eachother.

I think thats 4 of us who use them currently?

nice work Ness, satisfying isn't it?

[The Advent Profile]

Speaking of lan party, could start the plan for a new one.

[Sparky Profile]

[UW Ness Profile]

[The Advent Profile]

[UW Ness Profile]

[Coca-Cola Profile]

[Verman Profile]

There are a million things that could cause this.

First, if you made any changes in the bios, set it back to default. Usually though if things are messed up here you don’t get much past post if at all. But, it’s the first thing I would try.

Second, if you still have both mem sticks on the same channel, move one over and see what happens. (channel 1A & 2A) Also, could be a bad stick. Run it with one stick at a time.

Third, something may be over heating. Most likely it's not the cpu. Normally when they get hot the system will just shut down. Go get a PSU tester. When it locks up, don’t turn it off, just pull the ATX plug (24 pin) out and plug it into the tester. Check the P.G value. If zero, replace PSU. Testers are around $20.

Forth, if you have access to another machine, try your video card in it. Chances are it’s not the video card, and worth a try before shipping it off. Could save you some money in shipping and restock fee’s.

If none of the above works, contact MB (help me with this cheap piece of shit) support.

This is the same symptom the 3 computers had, that I just fixed. 2 had bad MB's and the other was the PSU.

Let us know what the out come is.

[DOZER Profile]

Hmmmmm.......what PSU do you have in there?

[Bib Fortuna Profile]

I had similar problems with my Dell years ago. Turned out it was poor ventilation. I just moved the box a couple of inches from the side of the desk and bammo... problem went away.